Follow These 11 Steps Before Turning Your AC On

Share on facebook
Share on twitter
Share on linkedin
Share on pinterest

Alot goes into turning on your air conditioner than just clicking a button. There are a few steps you can do to restore your unit to work and make sure you’re getting the most out of it. Not only would you want it to operate well the first time you turn it on, but you also want it to run effectively during the summer when it is most needed. An efficient AC can be ensured with adequate AC repair in Bowling Green, KY.

Take these 11 steps before turning on the AC

Step 1: Change the filter

Your air conditioner filter should be replaced every three months, on average. Replace your old air filter before switching from heating to cooling. If you have a reusable one, washed its thoroughly. Unclean air filters can severely damage the air quality and have you breathing toxins.

Step 2: Check the condenser unit

Check for leaves, vines, dirt, or other obstructions in or around the outside condenser unit. The outdoor condenser is exposed to more trash and hence but be clear of any obstruction.

Step 3: Clear the vents

Inspect your air vents to see whether they’re open, and nothing is impeding the passage of air.

Step 4: Inspect the exposed ductwork

Check for leakage in any visible ductwork, which might jeopardize your air conditioners capacity to chill your home.

Step 5: Check the drain line

Examine the drain pipe near the indoor cooling coil to ensure it is clear of obstructions. Often, things can get stuck in the pipe, causing a leak from the interior unit. 

Step 6: Check the circuits

Examine the circuits to ensure that all electrical connections are operational. A faulty circuit will prohibit your air conditioner from starting.

Step 7: Ensure that the unit is receiving power

Make sure the electricity is switched on at the air conditioning system. Ensure good connectivity for electric wirings. If you’ve had a short-circuit recently, get your wiring checked by a professional.

Step 8: Inspect the refrigerant lines

For maximum performance, coolant connections should be adequately insulated. Help for AC repair in Bowling Green, KY, is required if the insulation or refrigerant lines need to be repaired.

Step 9: Ensure good outdoor electric wiring

Contact the best air conditioner repair near me right away if you see any damage or fraying on your outside electrical wire.

Step 10: Check the thermostat

A faulty thermostat can squander a significant amount of electricity. Consider upgrading to a new programmable thermostat if you haven’t already.

Step 11: Replace the unit when it’s time

Air conditioners that are more than ten years old are cost-prohibitive to run. If your unit is more than ten years old, it’s probably time to replace it. A well-maintained air conditioner can keep you cool while also saving you energy and money.

By following these steps, you can get a better start on your air conditioner.

We can help you saved money on AC repairs, maintenance, and installation jobs. If you’re planing for the best air conditioner repair near me, call us at 270-904-3715 or leave an email at [email protected]  

Scroll to Top